HEIDENHAIN MANUALPLUS 620 - Page 718

718 HEIDENHAIN Technical Manual MANUALplus 620
Assigning the
compensation
value tables to the
axes
General relationship for *.CMA tables:
[Axis in column from *.com] = F(Axis in column from *.cma, in which *.com
is entered)
Enter the compensation-value tables in a table of the type <*.CMA> (standard
name config.cma).
(for table formatting, see the chapter Tables):
 Enter a column for each axis to be compensated. The column names must
match the axis keys from CfgAxes/axisList.
 Enter the names of the compensation-value tables (*.com) line-by-line in the
appropriate axis columns.
You can assign more than one compensation value table to each axis,
however only one table can be active.
 Activate the compensations with an * in the column ACTIVE, which can be
entered via the table editor or via the PLC (SQL server).
All compensations in this line become active.
Example:
Z axis = F(Y axis); axis sag compensation
Y axis = F(Y axis); nonlinear compensation
The first line is active.
Entries:
CMA table