818 HEIDENHAIN Technical Manual MANUALplus 620
MP_hscMode
Only for HSC filters: HSC mode
Available from NCK software version: 597 110-05.
Format: Selection menu
Selection: The HSC mode defined here is effective for HSC filters (not
advanced HSC filters). The machine operator can use Cycle 32
or FN17: ID260 in the NC program to overwrite this setting.
Smoothing
HSC mode: Finishing
Roughing
HSC mode: Roughing
Default: Smoothing
Access: LEVEL3
Reaction: RUN
MP_defaultManualOrder
Globally effective order of the mean-value filter in the Manual
operating modes
Available from NCK software version: 597 110-05.
Format: Numerical value
Input: 1 to 51
Only odd integers are permitted input values! If you enter an
odd number, the MANUALplus 620 displays an error message.
Default: 11
Access: LEVEL3
Reaction: RUN
MP_manualFilterOrder
Axis-specific order of the mean-value filter for the Manual
operating modes. Overwrites the value in
MP_defaultManualOrder (CfgFilter).
Available from NCK software version: 597 110-05.
Format: Numerical value
Input: 1 to 251
Only odd integers are permitted input values! If you enter an
even number, the MANUALplus 620 displays an error message.
Default: 11
Access: LEVEL3
Reaction: RUN
To Next Page
Loading...
