HEIDENHAIN MANUALPLUS 620 - Page 822

822 HEIDENHAIN Technical Manual MANUALplus 620
Machine parameters up to NCK software version 597 110-04:
MP_typeFilter1
Type of the first nominal position value filter
Available from NCK software version: 597 110-01.
Format: Selection menu
Selection: Off
Filter 1 is deactivated (recommended for lathes)
Position
Axis position (for linear and rotary axes)
CutterLocation
For rotary axes
Default: Off
Access: LEVEL3
Reaction: RESET
MP_orderFilter1
Order of first nominal position value filter
Available from NCK software version: 597 110-01.
Format: Numerical value
Input: 1 to 31
Default: 11
Access: LEVEL3
Reaction: RESET
MP_typeFilter2
Type of the second nominal position value filter
Available from NCK software version: 597 110-01.
Format: Selection menu
Selection: Off
Filter 2 is not active
Position
Axis position (for linear and rotary axes)
(recommended for lathes)
CutterLocation
for rotary axes (do not use for lathes)
Default: Position
Access: LEVEL3
Reaction: RESET
MP_orderFilter2
Order of second nominal position value filter
Available from NCK software version: 597 110-01.
Format: Numerical value
Input: 1 to 31
Default: 11
Access: LEVEL3
Reaction: RESET