HEIDENHAIN MANUALPLUS 620 - Page 823

January 2012 6.16 The Control Loop 823
MP_filter1Shape
Form of the first nominal position value filter
Available from NCK software version: 597 110-01.
Format: Selection menu
Selection: Off
Switched off
Average
Mean-value filter
Triangle
Triangle filter
HSC
High-speed cutting filter (cannot be used for lathes)
Default: Off
Access: LEVEL3
Reaction: RUN
MP_filter1LimitFreq
Limit frequency of the first nominal position value filter
Available from NCK software version: 597 110-01.
Format: Numerical value
Input: 10.000 000 000 to 100 [Hz]
Default: 66 [Hz]
Access: LEVEL3
Reaction: RUN
MP_filter2Shape
Form of the second nominal position value filter
Available from NCK software version: 597 110-01.
Format: Selection menu
Selection: Off
Switched off
Average
Mean-value filter
Triangle
Triangle filter
HSC
High-speed cutting filter (cannot be used for lathes)
Default: Off
Access: LEVEL3
Reaction: RUN
MP_filter2LimitFreq
Limit frequency of the second nominal position value filter
Available from NCK software version: 597 110-01.
Format: Numerical value
Input: 10.000 000 000 to 100 [Hz]
Default: 40 [Hz]
Access: LEVEL3
Reaction: RUN