•
Interconnect the two Virtual Chassis switches using the 10-Gigabit Ethernet SFP+
uplink ports. For more information, see “Interconnecting Two Virtual Chassis for QFabric
System Control Plane Redundancy” on page 271.
•
Ensure that 1000BASE-T SFP transceivers are installed in port 0 and port 1 on both
Control Boards for each QFX3008-I Interconnect Device. See “Interface Specifications
for Control Plane Connections for the QFabric System” on page 124 and “Installing a
Transceiver in a QFX Series Device” on page 374.
•
Ensure that you have four RJ-45 patch cables available for each Interconnect device.
For cable specifications, see “Cable Specifications for Control Plane Connections for
the QFX Series” on page 129.
Copyright © 2012, Juniper Networks, Inc.280
QFX3000 Hardware Documentation
To Next Page
Loading...
