Please enter the Director Group 0 IP address and prefix: ip address/prefix
Please enter the Director Group 1 IP address and prefix: ip address/prefix
5. Enter the gateway IP address for the Director group.
Please enter the Director Group gateway IP address: gateway ip address
6. Enter the default partition IP address. (You will use this addressto log in to the QFabric
on subsequent connections.)
Please enter the QFabric default partition IP address: ip address
7. Enter the MAC address information.
Please enter the starting MAC address: mac address
Please enter the number of MAC addresses: number of mac addresses
NOTE: The minimum number of MAC addresses accepted is 4000.
8. Enter the QFabric system serial ID number.
Please enter the QFabric serial ID: serial id
9. Create the Director device root password.
Please enter a Director device root password: director-device-password
Please re-enter the password: director-device password
10. Create a password for the QFabric system components.
Please enter a password for QFabric components (Node devices, Interconnect
devices, and infrastructure): component-password
Please re-enter the password: component-password
Note: please record your passwords for recovery purposes.
CAUTION: Carefully save your passwords for future reference, because
they cannot be recovered on a QFabric system.
11. Confirm the initial configuration. Ensure that the information is accurate before
proceeding.
Does the following configuration appear correct?
Initial Setup Review Director Group 0 IP/prefix [10.49.214.74/24]
Director Group 1 IP/prefix [10.49.214.75/24]
Director Group gateway IP [10.49.214.254]
QFabric default partition IP [10.49.214.150]
Starting MAC address [00:11:00:00:00:00]
289Copyright © 2012, Juniper Networks, Inc.
Chapter 23: Performing the Initial Configuration
To Next Page
Loading...
Need help?
General
