Juniper QFX Series User Manual

Number of MAC addresses [4000]
QFabric serial ID [qfsn-123456789]
Director device password [********]
QFabric component password [********]
12. Confirm the initial setup.
Initial Setup
Confirmation
[y/n]: yes
CAUTION: Resetting this initial configuration requires assistance from
Juniper Networks customer support or “Performing a QFabric Switch
Recovery Installation on the DirectorGroup”on page 410. As a result, make
sure you are certain the values you entered are correct before you enter
yes.
13. The director device displays the configuration.
Initial Setup
Completion
Saving temporary configuration...
Configuring peer...
Configuring local interfaces...
Configuring interface eth0 with [10.49.214.74/24:10.49.214.254]
Configured interface eth0 with [10.49.214.74/24:10.49.214.254]
Configuring the QFabric software with an initial pool of 4000 MAC addresses
[00:11:00:00:00:00 - 00:11:00:00:0f:3b]
Configuring the QFabric default partition IP address [10.49.214.150]
Reconfiguring the QFabric software static configuration
Applying the new Director device password
Applying the QFabric component password
Configuration complete. Director Group services will auto start within 30
seconds.
Copyright © 2012, Juniper Networks, Inc.290
QFX3000 Hardware Documentation

Juniper QFX Series Specifications

General

Category	Switch
Series	QFX
Form Factor	1U, 2U, and modular chassis options
Power Supply	Redundant, hot-swappable power supplies
Cooling	hot-swappable fans
Virtual Chassis	Supported on certain models
Typical Use	Data center, cloud
Operating System	Junos OS
Management	CLI
Key Features	High performance, low latency, automation
Latency	Sub-microsecond latency
Port Density	Varies by model (e.g., QFX5100: up to 48x10GbE + 6x40GbE)