Juniper QFX Series - Installing an HDD Module in a QFX3100 Director Device

Backup Restoration
Completion
Saving temporary configuration...
Configuring peer...
Configuring local interfaces...
Configuring interface eth0 with [10.49.214.74/24:10.49.214.254]
Configured interface eth0 with [10.49.214.74/24:10.49.214.254]
Configuring the QFabric software with an initial pool of 4000 MAC addresses
[00:11:00:00:00:00 - 00:11:00:00:0f:3b]
Configuring the QFabric default partition IP address [10.49.214.150]
Reconfiguring the QFabric software static configuration
Applying the new Director device password
Applying the QFabric component password
Configuration complete. Director Group services will auto start within 30
seconds.
Related
Documentation
• Gaining Access to the QFabric Switch Through the Default Partition
• QFabric Switch Initial and Default Configuration Information
• Installing and Connecting a QFX3100 Director Device on page 213
• Performing a QFabric Switch Recovery Installation on the Director Group on page 410
• request system software configuration-backup
Copyright © 2012, Juniper Networks, Inc.292
QFX3000 Hardware Documentation