Omron FQ2-S/CH Series

Menu Tables
456
FQ2-S/CH User’s Manual
Inspection
Details
(Search*
2
)
Model parameter
Rotation
Sets the angle range for the registered
model.
No (Default)
Yes
Scene p. 222
Angle range −180 to 180
(Defaults: Lower limit: −180
Upper limit: 180)
Scene p. 222
Stability Sets whether priority is given to mea-
surement stability or speed.
1 to 15 (Default: 12) Scene p. 223
Accuracy Sets whether priority is given to mea-
surement position accuracy or speed.
1 to 3 (Default: 2) Scene p. 223
Meas. Parameter
Sub-pixel
You can increase the accuracy of
measurement positioning.
No (Default)
Yes Scene p. 219
Meas. Parameter
Extraction condi-
tion
Scene
p. 221
Candidate
level
Sets the detection target to only
objects with a correlation above the
specified candidate level.
0 to 100
Default: 80 Scene
Extraction X
Results are output only for objects with
a measured X coordinate that is within
this range.
−999,999,999.9999 to 999,999,999.9999
(Defaults:
Lower limit: −999,999,999.9999
Upper limit: 999,999,999.9999)
Scene
Extraction Y
Results are output only for objects with
a measured Y coordinate that is within
this range.
−999,999,999.9999 to 999,999,999.9999
(Defaults:
Lower limit: −999,999,999.9999
Upper limit: 999,999,999.9999)
Scene
Detection
count
Sets the maximum number of detec-
tion results to output.
1 to 32
Default: 32
Scene
Multi-point out-
put
Sets whether to output only the result
with the highest correlation, or to out-
put all results that meet the specified
extraction conditions.
ON (Default)
OFF
Scene p. 221
Sorting method
Sets the sort condition to use when
multiple measurement results meet
the extraction conditions.
Corr. ascending order
Corr. descending order (Default)
Pos.X ascending order
Pos.X descending order
Pos.Y ascending order
Pos.Y descending order
Scene p. 220
Output parameter
Reflect
You can specify whether to reflect the
ment results of an inspection item in
the overall judgement.
None
Yes (Default) Scene p. 222
Menu command Description Setting range Data