Adjusting the Images That Were Taken
FQ2-S/CH User’s Manual
95
3
Taking Images
Setting the Image to Filter (Source Image)
You must set the image to which the filter is to be applied.
[Image] − [Image adjustment] − [Add filter] − (Filter item to select)
1 Press [ ] − [Source image] on the right of the display.
2 Set the source image to [Camera] or [Prev.].
Setting the Region to Filter
You can specify the region to which to apply the filter.
This setting does not exist in the Color Gray Filter item.
[Image] − [Image adjustment] − [Add filter] − (Filter item to select)
Parameter Setting Description
Source image
Camera
(camera image) The filter is applied to the image that is taken by the Camera.
Prev.
(previous image)
The filter is applied to the image that resulted from the previous
filter items or position compensation items in the processing
order.
1 Press [ ] − [Filter region] on the right of the
display.
2 Adjust the size and position of the region to
which the filter is to be applied.
To fine-tune the region, press [ ]
− [Console] on
the right of the display to display the console.
This will allow you to change the coordinates of the
rectangle at the pixel level.
Drag to move the region.
Drag a corner to size the rectangle.
To Next Page
Loading...
