© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
SPM/ RPM
(Strides/
Revolutions
Per Minute
Non-
Treadmills
only)
The console will display the Pulse. The pulse is
showing a count of zero crossings from the
generator. RPM shows a software averaged version
of pulse.
Use , keys to view the following RPM readings.
PULSE
MIN
Press the CLEAR
key to return to
Hardware
Validation
Incline/
Crossramp
Two numbers will be displayed, the percent of lift and
A/D number related to the current lift position. The
A/D (analog to digital) number represents the lift
potentiometer reading. The A/ D number will be in
the range of 0 to 255 or 0 to 32769.
The lift may be operated using the
INCLINE/CROSSRAMP keys. The incline
percentage and A/D numbers will change
accordingly. Care must be taken while operating the
lift in this mode because the normal upper and lower
range limits are not in effect. It is possible to operate
the lift to its physical limits and may cause the lift
Press the CLEAR
key to return to
Machine Test
Battery Test
(Non-
Treadmills)
BATTERY will scroll across the display.
Press the OK key
The console will display the battery test. Battery test
will display battery voltage.
Press the CLEAR
key to return to
Hardware
STRIDE POSITION TEST will scroll across the
display.
Press the CLEAR
key to return to
Hardware
Stride Position
Test
AMT12 (Open
Stride Only)
The low, high and actual stride positions will be
displayed. The low display shows the lowest position
reading achieved during the test. The high display
shows the highest position reading achieved during
the test. The actual display changes with the current
stride position. Stride on the AMT to the maximum
Press the CLEAR
To Next Page
Loading...
Need help?
General
