SERVICE PROGRAM MODE TABLES
B079/B082 5-60 SM
SP6 Mode Number Function and [Setting]
Europe
Bit 0 1
2 DLT SEF 8-K SEF
1 LT SEF 16-K SEF
6016*
0 LT LEF 16-K LEF
6017* Sheet Through Magnification Adjusts the magnification in the sub-scan
direction for ADF mode.
[–50.0 ~ +50.0 / 0.0 / 0.1%/step]
Use the key to toggle between + and - before
entering the value
6105* Staple Position Adjustment Adjusts the staple position in the main scan
direction when using the two-tray finisher.
[–3.5~+3.5 / 0.0 / 0.5 mm step]
Press
to toggle
±
. A larger value shifts the
staple toward the edge of the paper.
Punch Hole Adjustment Adjusts the punch hole position.
[–7~+7 / 0 / 0.5 mm steps]
Press
to toggle
±
. A larger value shifts the
holes toward the edge of the paper.
1* 2-Holes 2-hole punches for Japan, North America,
Europe, and 4-hole punches for Northern Europe.
6113*
2* 3-Holes 3-hole punches for North America, and 4-hole
punches for Europe.
Fold Position Adjustment Allows fine adjustment of the fold position on
paper when the Booklet Finisher is connected
and used.
1* A3/DLT [-30~+30 / 0 / 0.5 mm]
2* B4 [-20~+20 / 0 / 0.5 mm]
6902*
3* A4/LT [-15~+15 / 0 / 0.5 mm]
To Next Page