USING THE DEBUG LOG
SM 5-99 B079/B082
Service
Tables
4. Under “5857 Save Debug Log”, press .
COPY : SP-5-857-002
Save Debug Log
Target (1:IC Card 2:HDD)
_2_
Initial 0
5. Press to select the IC Card or press to select the HDD, then press .
Saves the debug log directly to the IC card inserted in the controller slot. If the machine
does not have an HDD unit, or if the HDD is temporarily disabled, be sure to use this
setting.
Saves the debug log to HDD.
NOTE: This setting is normally set to “2” for writing the debug log to the HDD.
Setting the Timing for Debug Log Acquisition
You can specify that errors related to specific events be recorded in the debug log.
NOTE: More than one event can be selected for retrieval.
1. Enter then press .
SP5858 (Debug Save When) contains the following features:
1 Engine SC Error
Saves data when an engine-related SC code is
generated.
2 Controller SC Error
Saves debug data when a controller-related SC Code is
generated.
3 Any SC Error
Saves data only for the SC code that you specify by
entering code number.
4 Jam Saves data for jams.
2. To save data for items 1, 2, or 4, press the appropriate key. The example below
shows the “Engine SC Error” selected after pressing .
COPY : SP-5-858-001
Debug Save When
Engine SC Error
OFF ON
Press “ON” then press .
To Next Page
Loading...
