USING THE DEBUG LOG
B079/B082 5-98 SM
5.7 USING THE DEBUG LOG
This machine provides a Save Debug Log feature that allows saving and retrieving
error information for later analysis. Every time an error occurs the debug
information is recorded in volatile memory but is lost every time the machine is
switched off and on. The Save Debug Log feature provides two new features:
• The customer or CE can save the debug log to HDD as soon as an error occurs.
This is especially useful for recording information about errors that do not
generate an SC code.
• The CE can copy the information to HDD and then to an IC card for later
analysis.
When an error occurs while the machine is operating, a debugging log is generated
in memory but this log is lost as soon as processing resumes or after the machine
is cycled off and on.
5.7.1 CAPTURING DEBUGGING INFORMATION
The machine must be setup up correctly with SP codes in order for the debug log
to be captured for later retrieval. Otherwise, the debugging log is lost.
The debug information cannot be saved the until the “Save Debug Log” function
has been switched on and a target has been selected.
Switching On the Debug Log Feature
1. Enter the SP mode.
• Press then use the 10-key pad to enter .
• Press and hold down for more than 3 seconds.
• Enter then press .
2. Under “5857 Save Debug Log”, press .
COPY : SP-5-857-001
Save Debug Log
On/Off (1:ON 0:OFF)
_1_
Initial 0
3. Press then press .
To Next Page
Loading...
