SOFTWARE DOWNLOAD
SM 5-85 B079/B082
Service
Tables
4. Press Execute, and then follow the prompts on the display to complete the
procedure.
5. Make sure that you perform the following settings:
• Do the laser beam pitch adjustment (SP2-109).
• Do the printer and scanner registration and magnification adjustments (!
3.21 Replacement and Adjustment, “Copy Adjustments”).
• Do the touch screen calibration (! 3.21.4 Replacement and Adjustment,
“touch screen calibration”).
• Referring to the SMC data lists, re-enter any values, which had been
changed from their factory settings.
• Do SP 3-001-2 (ID Sensor Initial Setting) and SP4-911-1 (HDD media
check).
6. Check the copy quality and the paper path, and do any necessary adjustments.
5.1.10 SOFTWARE RESET
The software can be reboot when the machine hangs up. Use the following
procedure.
Turn the main power switch off and on.
-or-
Press and hold down together for over 10 seconds. When the machine
beeps once release both buttons. After “Now loading. Please wait” is displayed for
a few seconds the copy window will open. The machine is ready for normal
operation.
To Next Page
Loading...
