Detailed
Descriptions
IMAGE FUSING AND PAPER EXIT
SM 6-95 B079/B082
Here are some important points to keep in mind about this new feature:
• If a request to start a print job is received during cleaning cycle in the timing chart
above, cleaning stops and the new print job starts. During a normal print job, the
fusing/exit motor switches on as soon as the paper reaches the registration roller,
but in this case the fusing/exit motor remains on.
• If a request to enter the Off mode is received while hot roller stripper cleaning is
in progress, the machine enters the Off mode and the cleaning cycle stops
immediately.
• If the machine switches to any of the energy saver modes (low power mode, etc.)
the cleaning cycle completes and does not halt.
• The cleaning cycle is not interrupted during free rotation of the hot roller when
the machine is getting ready to print.
• Opening the front door, however, will stop the cleaning cycle.
To Next Page
Loading...
