BIT SWITCHES
SM 43 B547
Fax Option
B547
Width and
reduction
A4: A4 (8.3"), no reduction
B4: B4 (10.1"), no reduction
A3: A3 (11.7"), no reduction
I/O rate
0: 0 ms/line 10: 10 ms/line
25: 2.5 ms/line 20: 20 ms/line
5: 5 ms/line 40: 40 ms/line
Note:
“40” is displayed while receiving a fax message using AI short
protocol.
System Switch 01 - Not used (Do not change the factory settings.)
System Switch 02 SP No. 1-101-003
No FUNCTION COMMENTS
0-3 Not used Do not change the settings.
4
File retention time
0: Depends on User Parameter
24 [18(H)]
1: No limit
1: A file that had a communication error will not be
erased unless the communication is successful.
5 Not used Do not change the setting.
6
to
7
Memory read/write by RDS
Bit 7 6 Setting
0 0 Always disabled
0 1 User selectable
1 0 User selectable
1 1 Always enabled
(0,0): All RDS systems are always locked out.
(0,1), (1,0): Normally, RDS systems are locked out,
but the user can temporarily switch RDS on to allow
RDS operations to take place. RDS will
automatically be locked out again after a certain
time, which is stored in System Switch 03. Note that
if an RDS operation takes place, RDS will not switch
off until this time limit has expired.
(1,1): At any time, an RDS system can access the
machine.
System Switch 03 SP No. 1-101-004
No FUNCTION COMMENTS
0
to
7
Length of time that RDS is
temporarily switched on when
bits 6 and 7 of System Switch
02 are set to “User selectable”
00 - 99 hours (BCD).
This setting is only valid if bits 6 and 7 of System
Switch 02 are set to “User selectable”.
The default setting is 24 hours.
System Switch 04 SP No. 1-101-005
No FUNCTION COMMENTS
0
Program registration list output
key display selection
This setting determines whether the key to print the
program registration list is displayed on the screen.
1-2 Not used Do not change the settings.
To Next Page
Loading...
