Rohde & Schwarz MXO 4 Series - Page 798

Remote control commandsMXO 4 Series
798User Manual 1335.5337.02 ─ 07
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
<LIN scale>
Usage: Asynchronous command
17.16.6.2 Trigger
Trigger commands for serial buses affect the current trigger source. Therefore, set the
trigger source to the required serial bus with TRIGger:EVENt<ev>:SOURce before
sending the bus-specific trigger commands.
TRIGger:LIN:TYPE.........................................................................................................798
TRIGger:LIN:CHKSerror................................................................................................. 799
TRIGger:LIN:DCONdition................................................................................................799
TRIGger:LIN:DMIN.........................................................................................................799
TRIGger:LIN:DPOSition..................................................................................................799
TRIGger:LIN:ICONdition................................................................................................. 800
TRIGger:LIN:IMAX......................................................................................................... 800
TRIGger:LIN:IMIN.......................................................................................................... 800
TRIGger:LIN:IPERror..................................................................................................... 800
TRIGger:LIN:SYERror.................................................................................................... 801
TRIGger:LIN:TYPE <Type>
Selects the trigger type for LIN analysis.
Parameters:
<Type> STARtframe | ID | IDDT | WKFR | ERRC
STARtframe
Start of the frame. Triggers on the stop bit of the sync field.
ID
Sets the trigger to one specific identifier or an identifier range.
IDDT
Combination of identifier and data conditions.
WKFR
Wake-up frame.
ERRC
Error condition. Define the error types with:
TRIGger:LIN:CHKSerror
TRIGger:LIN:IPERror
TRIGger:LIN:SYERror
*RST:
STARtframe
Usage: Asynchronous command
Manual operation: See "Type" on page 396
Protocols