Scanlab RTC6 PCIe Board - Page 320

RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
320
innovators for industry
Comments
(cont’d)
• The following command calls are executed in the same way:
– activate_fly_2_axes( 1, ScaleX, 0, 2, ScaleY, 0 ) =
activate_fly_2d( ScaleX, ScaleY )
or
activate_fly_xy( ScaleX, ScaleY )
– activate_fly_2_axes( 1, ScaleX, EncX, 2, ScaleY, EncY ) =
or
activate_fly_xy_encoder( ScaleX, ScaleY, EncX, EncY )
“xy” and “2d” are distinguished with wait_for_1_axis and wait_for_2_axes !
– activate_fly_2_axes( 1, ScaleX, OffsetX, 2, ScaleY, OffsetY ) =
{
activate_fly_1_axis( 1, 1, ScaleX, OffsetX );
activate_fly_1_axis( 2, 2, ScaleY, OffsetY );
}
RTC4RTC6 New command.
RTC5RTC6 New command.
Version info Available as of DLL 617, OUT 617, RBF 623.
References activate_fly_1_axis
Variable
List Command
activate_fly_2_axes