Scanlab RTC6 PCIe Board - Set_Offset_Xyz_List

RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
708
innovators for industry
Variable
List Command
set_offset_xyz_list
Function Like set_offset_xyz, but a list command.
Call set_offset_xyz_list( HeadNo, XOffset, YOffset, ZOffset, at_once )
Parameters HeadNo Like set_offset_xyz. However, HeadNo = 4 is not available.
XOffset Like set_offset_xyz.
YOffset Like set_offset_xyz.
ZOffset Like set_offset_xyz.
at_once Like set_matrix_list.
RTC4RTC6 See set_offset_xyz.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
References set_offset_xyz, set_offset_list, set_defocus_list