RTC6 boards
Doc. Rev. 1.0.21 en-US
2 Product Overview
60
2.11.3 Restrictions with
RTC6 PCIe Boards
Availability of Technical Variants
RTC6 boards are available as RTC6 PCIe Boards and
RTC6 Ethernet Boards.
Peripheral Interfaces
The ADC add-on card (#121126, optional accessory
for the RTC5 PCI board) cannot be used with the
RTC6 PCIe Board. The RTC6 PCIe Board supplies the
two 10 V analog input ports ANALOG IN0 and
ANALOG IN1 at the McBSP/ANALOG
socket connector directly, see Chapter 4.6.6
”McBSP/ANALOG Socket Connector”, page 84.
Functionality
With RTC6 PCIe Boards, the McBSP/ANALOG
socket connector cannot be used in SPI mode, see
also Chapter 4.6.6 ”McBSP/ANALOG Socket
Connector”, page 84.
Known restrictions are mentioned in
RTC6_Release_Notes_Rev.n.n.n.pdf
.
2.12 Source Code for RTC6 User
Programs
2.12.1 Creating New RTC6 Source
Code
To create new source code for RTC6 user programs,
proceed as described in Chapter 6.2 ”Initialization
and Program Start-Up”, page 95 while observing
Chapter 2.12.2 ”Adapting RTC5 Source Code for the
RTC6 PCIe Board”, page 60.
2.12.2 Adapting RTC5 Source Code
for the RTC6 PCIe Board
User programs written for the RTC5 only become
usable on the RTC6 PCIe Board, if you modify the
program code as described in the following.
This is true even if program flow remains unchanged.
Mandatory Steps
(1) Ensure the following prerequisites are met:
– RTC6 PCIe Board is installed
– RTC6 board driver is installed for your
operating system
– The following files are present:
RTC6DLL.dll
or
RTC6DLLx64.dll
,
RTC6OUT.out
(with RTC6 PCIe Boards) or
RTC6ETH.out
(with RTC6 Ethernet Boards),
RTC6RBF.rbf
,
RTC6DAT.dat
,
*.CT5
(correction file(s))
Note,
RTC6OUT.out
/
RTC6ETH.out
,
RTC6RBF.rbf
,
RTC6DAT.dat
must all be in the same folder.
To Next Page
Loading...