Scanlab RTC6 PCIe Board - Auto_Change

RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
335
innovators for industry
RTC4RTC6 The functions for automatic self-calibration ( Command = 0…2) are (largely) unchanged.
New: Command = 3 and Command = 4.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
References set_hi, get_hi_pos, get_auto_cal, write_hi_pos
Ctrl Command auto_cal
Ctrl Command auto_change
Function Activates a one-time automatic list change.
Call auto_change()
Comments • auto_change is synonymous with auto_change_pos( 0 ) .
This starts the subsequent list at its beginning.
• See also comments for auto_change_pos.
RTC4RTC6 Unchanged functionality.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
References auto_change_pos, get_status, read_status