Scanlab RTC6 PCIe Board - Select_Serial_Set; Select_Serial_Set_List

RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
609
innovators for industry
Ctrl Command select_serial_set
Function Selects a serial-number-set for serial number control commands.
Call select_serial_set( No )
Parameters No Number of the desired serial-number-set.
As an unsigned 32-bit value.
Allowed value range: [0…3].
Only the two least significant bits are evaluated.
Comments • After initialization with load_program_file, serial-number-set 0 is selected.
• select_serial_set does not set the serial-number-set for serial number marking.
The list command select_serial_set_list is intended for that purpose.
• For usage of select_serial_set, see Chapter 7.5.2 ”Marking Serial Numbers”, page 210.
RTC4RTC6 New command.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
References select_serial_set_list, set_serial_step, get_serial
Undelayed
Short List
Command
select_serial_set_list
Function Selects a serial-number-set for serial number list commands (as well as for serial number
marking).
Call select_serial_set_list( No )
Parameters No Number of the desired serial-number-set.
As an unsigned 32-bit value.
Allowed value range: [0…3].
Only the two least significant bits are evaluated.
Comments • After initialization with load_program_file, serial-number-set 0 is selected.
• For usage of select_serial_set_list, see Chapter 7.5.2 ”Marking Serial Numbers”,
page 210.
RTC4RTC6 New command.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
References select_serial_set,set_serial_step_list, get_list_serial, mark_serial, mark_serial_abs