Scanlab RTC6 PCIe Board - Set_List_Jump

RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
680
innovators for industry
Undelayed
Short List
Command
set_list_jump
Function Produces an unconditional jump to the specified address within the RTC6 List Memory
upon execution. The next command there is executed immediately without delay.
Call set_list_jump( Pos )
Parameters Pos Absolute jump address [0…(2
23
–1)].
As an unsigned 32-bit value.
Comments • set_list_jump is synonymous with list_jump_pos. See the comments there.
RTC4RTC6 Unchanged functionality.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
References list_jump_pos