Scanlab RTC6 PCIe Board - Long_Delay

RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
523
innovators for industry
Normal List
Command
long_delay
Function Pauses further processing of the list for the specified time.
Call long_delay( Delay )
Parameters Delay Delay time. In bits.
As an unsigned 32-bit value.
1 bit equals 10 µs.
Allowed value range: 0  delay  (2
32
–1).
Comments • long_delay switches off the Signals for “Laser Active” Operation after a
LaserOff Delay, waits for a possible scanner delay and pauses further processing of the
list for the specified time.
• long_delay should always be called after changing the lamp current of a YAG laser to
obtain a constant laser power.
• list_nop corresponds to long_delay( 1 ) .
RTC4RTC6 Unchanged functionality. In addition: increased value range.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
References set_defocus_list