Scanlab RTC6 PCIe Board - Set_Fly_Tracking_Error

RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
652
innovators for industry
Ctrl Command set_fly_tracking_error
Function No function.
Call set_fly_tracking_error( TrackingErrorX, TrackingErrorY )
Parameters TrackingErrorX Tracking Error for the x axis. In units of 10 µs.
As a signed 32-bit value.
Allowed value range: [0…65,535]. Excessive bits are ignored.
TrackingErrorY Tracking Error for the y axis.
Otherwise, like TrackingErrorX .
Comments • To date, this command has no effect.
RTC4RTC6 New command.
RTC5RTC6 Changed functionality. To date, this command has no effect.
Version info Available as of DLL 600, OUT 600, RBF 600.
References –