Scanlab RTC6 PCIe Board - Eth_Set_Search_Cards_Timeout

RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
382
innovators for industry
Ctrl Command eth_set_search_cards_timeout
Function Sets a timeout value.
Call eth_set_search_cards_timeout( TimeOut )
Parameters TimeOut The timeout value. In µs.
As an unsigned 32-bit value.
Result None.
Comments • eth_set_search_cards_timeout is not available as a multi-board command (n_).
• The default timeout value is 5 ms.
• The timeout value is relevant for eth_search_cards and eth_search_cards_range.
RTC4RTC6 New command.
RTC5RTC6 New command.
Version info Available as of DLL 606, OUT 606, RBF 611.
References eth_search_cards, eth_search_cards_range