Scanlab RTC6 PCIe Board - Set_Softstart_Mode; Set_Softstart_Mode_List

RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
743
innovators for industry
Ctrl Command set_softstart_mode
Function No function.
Call set_softstart_mode( Mode, Number, Delay )
Parameters Mode As an unsigned 32-bit value.
Number As an unsigned 32-bit value.
Delay As an unsigned 32-bit value.
Comments • set_softstart_mode has no effect on the user program.
RTC4RTC6 Unchanged functionality.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
References –
Variable
List Command
set_softstart_mode_list
Function No function.
Call set_softstart_mode_list( Mode, Number, Delay )
Parameters Mode Like set_softstart_mode.
Number Like set_softstart_mode.
Delay Like set_softstart_mode.
Comments • See set_softstart_mode.
RTC4RTC6 New command.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
References –