Scanlab RTC6 PCIe Board - Set_Mcbsp_In_List

RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
692
innovators for industry
Normal List
Command
set_mcbsp_in_list
Function Like set_mcbsp_in, but a list command.
Restriction If the Option Processing-on-the-fly is not enabled, then set_mcbsp_in_list terminates the
Processing-on-the-fly process (even though it could not have been activated).
Call set_mcbsp_in_list( Mode, Scale )
Parameters Mode Like set_mcbsp_in.
Scale Like set_mcbsp_in.
Comments • If Mode > 5, then set_mcbsp_in_list is replaced by a list_nop
(get_last_error return code RTC6_PARAM_ERROR ).
• See set_mcbsp_in.
RTC4RTC6 New command.
RTC5RTC6 Unchanged functionality.
Version info Last change DLL 617, OUT 617: compatibility with “Fly Extension” Commands.
References set_mcbsp_in