Scanlab RTC6 PCIe Board - Changed Timing Behavior

RTC6 boards
Doc. Rev. 1.0.21 en-US
2 Product Overview
52
innovators for industry
Changed Timing Behavior
The following RTC4 list commands are processed by
the RTC6 PCIe Board as “short list commands”. This
can result in a changed timing behavior during
user program execution, see Section ”Normal, Short,
Variable and Multiple List Commands”, page 302.
• clear_io_cond_list
• list_call
• list_call_cond
• list_jump_cond (changed)
• list_return
• save_and_restart_timer
• set_extstartpos_list
• set_firstpulse_killer_list
• set_io_cond_list
• set_jump_speed
• set_laser_delays
• set_laser_timing (changed)
• set_list_jump
• set_mark_speed
• set_scanner_delays
• set_standby_list
• set_trigger (enhanced)
• set_wobbel (changed)
• write_8bit_port_list
• write_da_1_list
• write_da_2_lis
t
• write_da_x_list
• write_io_port_list
Lik
ewise, automatic delay adjustments can produce a
changed timing behavior, see Section ”Automatic
Delay Adjustments”, page 155.