Scanlab RTC6 PCIe Board - Set_Sky_Writing_Mode_List

RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
738
innovators for industry
Normal List
Command
set_sky_writing_mode_list
Function Like set_sky_writing_mode, but a list command.
Call set_sky_writing_mode_list( Mode )
Parameters Mode Like set_sky_writing_mode.
Comments • By set_sky_writing_mode_list, Sky Writing Mode 2 and Sky Writing Mode 3 can be
activated or deactivated even within a list (switching to or from Mode = 2 or 3).
Here, an already-begun Mark Command is finished with Sky Writing Mode 1 and the
next is started with it.
• Deactivation of Sky Writing Mode 1 by set_sky_writing_mode_list (switching from
Mode = 1 to 0) results in the addition of a Mark Delay defined prior to activation of
Sky Writing – provided that no other delay is in effect (for example, a Jump Delay).
RTC4RTC6 New command.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
References set_sky_writing_mode