Scanlab RTC6 PCIe Board - Changes to the RTC6 Command Set; Removed from RTC6 Command Set

RTC6 boards
Doc. Rev. 1.0.21 en-US
2 Product Overview
62
innovators for industry
2.13 Changes to the RTC6
Command Set
The most RTC5 commands are covered in the RTC6
command set. The following chapter describes the
few differences:
• Changed commands, see Chapter 2.13.1
”Changes to the RTC6 Command Set”, page 62
• Removed commands, see Chapter 2.13.2
”Removed from RTC6 Command Set”, page 62
list commands list command
2.13.1 Changes to the RTC6
Command Set
Meanings:
(n_) config_list
con
......................................... 344
get_dll_version
con
.................................. 397
(n_) get_hex_version
con
................................ 408
(n_) get_rtc_version
con
................................. 421
(n_) get_status
con
......................................... 428
(n_) get_sync_status
con
................................ 432
(n_) *init_fly_2d
con
........................................ 463
(n_) load_correction_file
con
.......................... 494
(n_) *load_fly_2d_table
con
........................... 501
(n_) load_program_file
con
............................ 509
(n_) *load_stretch_table
con
.......................... 512
(n_) mcbsp_init_spi
con
.................................. 545
(n_) number_of_correction_tables
con
.......... 551
(n_) select_cor_table
con
................................ 603
(n_) *set_auto_laser_control
con
................... 613
(n_) *set_auto_laser_params
con
................... 617
(n_) *set_auto_laser_params_list
ds
.............. 617
(n_) set_dsp_mode
con
................................... 630
(n_) *set_pixel_line
nor
................................... 712
(n_) set_trigger4
nor
....................................... 760
* Note: RTC6 command with extended functionality.
2.13.2 Removed from RTC6 Command
Set
free_rtc5_dll ............................................ 864
init_rtc5_dll ............................................. 864
rtc5_count_cards .................................... 864
con control command
nor normal list command
ds delayed short list command