Scanlab RTC6 PCIe Board - Set_Scanahead_Line_Params_List

RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
727
innovators for industry
Undelayed
Short List
Command
set_scanahead_line_params_list
Function Only for scan systems with SCANahead technology, for example, the excelliSCAN.
Like set_scanahead_line_params, but an undelayed short list command.
Call set_scanahead_line_params_list( CornerScale, EndScale, AccScale )
Parameters CornerScale Like set_scanahead_line_params.
EndScale Like set_scanahead_line_params.
AccScale Like set_scanahead_line_params.
Comment • set_scanahead_line_params_list takes effect upon the next to-be-calculated delay.
RTC4RTC6 New command.
RTC5  RTC6 New command.
Version info Available as of version DLL 600, OUT 600.
References set_scanahead_line_params