Scanlab RTC6 PCIe Board - Set_Control_Mode; Set_Control_Mode_List

RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
622
innovators for industry
Normal List
Command
set_control_mode_list
Function Like set_control_mode, but a list command.
Call set_control_mode_list( Mode )
Parameters Mode Like set_control_mode.
Comments • The counter for External Starts is not reset by set_control_mode_list.
RTC4RTC6 Unchanged functionality for the bits that are also used on the RTC4.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
Last change DLL 605, OUT 605: Bit #4.
References set_control_mode