Scanlab RTC6 PCIe Board - Set_Start_List; Set_Start_List_1; Set_Start_List_2

RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
746
innovators for industry
Ctrl Command set_start_list
Function Opens the RTC6 List Memory for writing of list commands and sets the input pointer to
the start of the specified list (“List 1” or “List 2”).
Call set_start_list( ListNo )
Parameters ListNo Number of the list in which the input pointer should be set.
As an unsigned 32-bit value.
Allowed values: [uneven: “List 1“, even: “List 2“].
Comments • set_start_list is synonymous with set_start_list_pos for Pos = 0.
• Alternatively, set_start_list_1 and set_start_list_2 (with no parameter) can be used.
RTC4RTC6 Unchanged functionality.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
References execute_list, read_status, set_start_list_pos
Ctrl Command set_start_list_1
Function See set_start_list.
Call set_start_list_1()
RTC4RTC6 Unchanged functionality.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
References set_start_list
Ctrl Command set_start_list_2
Function See set_start_list.
Call set_start_list_2()
RTC4RTC6 Unchanged functionality.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
References set_start_list