Scanlab RTC6 PCIe Board - Set_Port_Default_List

RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
717
innovators for industry
Comments
(cont’d)
• If the value for Port is invalid, then set_port_default is not executed
(get_last_error return code RTC6_PARAM_ERROR ).
• The default values for the output ports 0…2 can also be defined by
set_laser_off_default.
RTC4RTC6 New command.
In RTC4 Compatibility Mode, the RTC6 multiplies Value for Port = 0/1 by 4.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
References set_laser_off_default, set_default_pixel
Ctrl Command set_port_default
Undelayed
Short List
Command
set_port_default_list
Function Like set_port_default, but a list command.
Call set_port_default_list( Port, Value )
Parameters Port Like set_port_default.
Value Like set_port_default.
Comments • See set_port_default.
RTC4RTC6 New command.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 609, OUT 609, RBF 614.
References set_port_default