Scanlab RTC6 PCIe Board - Set_Laser_Pulses_Ctrl

RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
677
innovators for industry
Ctrl Command set_laser_pulses_ctrl
Function Like set_laser_pulses, but a control command.
Call set_laser_pulses_ctrl( HalfPeriod, PulseLength )
Parameters HalfPeriod Like set_laser_pulses.
PulseLength Like set_laser_pulses.
Comments • See set_laser_pulses.
RTC4RTC6 New command.
In RTC4 Compatibility Mode: like set_laser_pulses.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
References set_laser_pulses, set_laser_timing