RTC6 boards
Doc. Rev. 1.0.21 en-US
7 Basic Functions for Scan Head Control and Laser Control
141
7.1.3 Marking Single Dots
To mark a single point, the Signals for “Laser Active”
Operation must be switched on for the desired time
period, see laser_on_list, laser_on_pulses_list,
para_laser_on_pulses_list and Chapter 7.4 ”Laser
Control”, page 184.
Alternatively, a single dot can also be marked by a
timed Mark Command of length zero, see
Chapter 8.9 ”Timed Commands”, page 274.
To Next Page
Loading...