Scanlab RTC6 PCIe Board - Page 27

RTC6 boards
Doc. Rev. 1.0.21 en-US
1 About this Manual
27
innovators for industry
Flash Memory Non-volatile memory on the RTC6 board that replaces the EEPROM
of the RTC5 board.
FPGA Field programable gate array on the RTC6 board.
Hardware Reset New start after powering the RTC6 board.
Synonym: “power up”, “power cycle“.
Hard Jump Direct output to a specified position.
Decomposition into Microsteps into a single 10 µs clock cycle.
High-Bandwidth Return Channel
Multiplexing
Functionality not yet released.
iDRIVE Scan Systems In this manual, the term subsumes, for example, the following
SCANLAB products: intelliSCAN, intelliSCAN
de
, intelliSCAN
se
,
intelliDRILL, intellicube, intelliWELD, varioSCAN
de
,
powerSCAN II 50i, excelliSCAN.
Image Field Synonym: Working Field.
intelliSCAN In this manual, the term subsumes, for example, the following
SCANLAB products: intelliSCAN, intelliSCAN
de
, intelliSCAN
se
,
intelliDRILL, intellicube, intelliWELD, powerSCAN II 50i.
Jump Command Serves to move the scan system axes to a new position while the
laser is off.
See also Section ”Jump Commands”, page 137.
See 2D Jump Commands, page 310 and 3D Jump Commands,
page 310.
Laser Control Signals LASER1, LASER2, LASERON. See, for example, Chapter 7.4.1
”Enabling, Activating and Switching Laser Control Signals”,
page 184.
LSB Least Significant Bit.
Mark Command Serves to perform marking motions while the laser is switched on.
Examples: mark, arc and ellipse.
See 2D Mark Commands, page 310, and 3D Mark Commands
(1)
,
page 310.
McBSP Multi channel Buffered Serial Port.