Scanlab RTC6 PCIe Board - Set_Defocus_Offset_List

RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
627
innovators for industry
Variable
List Command
set_defocus_offset_list
Function Like set_defocus_offset, but a list command.
Restriction Like set_defocus.
Call set_defocus_offset_list( Shift )
Parameters Shift Like set_defocus.
Comments • See set_defocus_offset.
• See set_defocus_list.
• Even though set_defocus_offset_list is a short list command, execution of the directly
following list command is delayed by a few clock cycles due to the intermediate jump
to the changed z position. The extent of this delay depends on the size of the specified
focus shift; but it is at least 10 µs, even if Shift = 0.
RTC4RTC6 New command.
In RTC4 Compatibility Mode, the RTC6 multiplies the specified value for Shift by 16.
RTC5RTC6 Unchanged functionality.
In RTC5 Compatibility Mode, the RTC6 multiplies the specified value for Shift by 16.
Version info Available as of DLL 609, OUT 609, RBF 614.
References set_defocus_offset, set_defocus_list