Scanlab RTC6 PCIe Board - Page 369

RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
369
innovators for industry
Comments • For error handling, Chapter 6.8 ”Error Handling”, page 130.
• eth_get_last_error and n_eth_get_last_error are available even without explicit
access rights to a specific RTC6 Ethernet Board.
• The board-specific error variables LastError and AccError (Chapter 6.8 ”Error
Handling”, page 130) are neither generated nor altered by eth_get_last_error.
• Each eth_get_last_error error also leads to a get_last_error error RTC6_ETH_ERROR .
• If with an RTC6 Ethernet Board command call (internally) several errors occur
successively, eth_get_last_error probably returns only the very last error (for example,
only “not_acquired”). The actual error causes can be identified by eth_get_error
because it returns the accumulated errors.
RTC4RTC6 New command.
RTC5RTC6 New command.
Version info Available as of DLL 606, OUT 606, RBF 611.
References eth_get_error, get_error, reset_error, set_verify
Ctrl Command eth_get_last_error