RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
404
RTC4RTC6 New command.
In RTC4 Compatibility Mode, the RTC6 multiplies the specified values for x, y, z and Defocus
by 16. The allowed value range decreases accordingly.
Even in RTC4 Compatibility Mode, all returned values are in the RTC6 20-bit range.
RTC5RTC6 Unchanged functionality.
In RTC5 Compatibility Mode, the RTC6 multiplies the specified values for z and Defocus by
16. The allowed value range decreases accordingly.
Even in RTC5 Compatibility Mode, all returned values are in the RTC6 20-bit range.
Version info Available as of DLL 600, OUT 600, RBF 600.
References select_cor_table
Ctrl Command get_galvo_controls
To Next Page
Loading...