RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
564
Comments
(cont’d)
• If the laser focus has been already previously moved to a safe park position, then
park_position is a short list command with no effect.
• park_position switches off the Signals for “Laser Active” Operation after a
LaserOff Delay, but does not activate a scanner delay afterward.
RTC4RTC6 New command.
In RTC4 Compatibility Mode, the RTC6 multiplies the specified values for
X
and
Y
by 16.
The allowed value range decreases accordingly.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
References park_return
Variable
List Command
park_position
To Next Page
Loading...