Scanlab RTC6 PCIe Board - Page 808

RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
808
innovators for industry
Comments
(cont’d)
• sync_slaves is not executed (get_last_error return code RTC6_BUSY ), if:
– the BUSY list execution status of the addressed board is currently set
– the INTERNAL-BUSY list execution status of the addressed board is set
• sync_slaves is even executed, if:
– a list has been paused by set_wait (PAUSED list execution status is set)
RTC4RTC6 New command.
RTC5RTC6 Unchanged functionality. However:
Master/Slave functionality has been changed.
Version info Available as of DLL 600, OUT 600, RBF 600.
Last change DLL 615: sync_slaves has no function anymore.
References get_master_slave, get_sync_status, master_slave_config
Ctrl Command sync_slaves