Scanlab RTC6 PCIe Board - Page 863

RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
863
innovators for industry
Comments • NoDelay is only relevant, if the SCANahead control mode on the RTC6 board has been
activated by set_scanahead_params.
• write_port_list( NoDelay = 0 ) behaves (depending on Port ) similar to:
– write_da_x_list
– write_8bit_port_list
– write_io_port_list
– set_laser_pin_out_list
RTC4RTC6 New command.
RTC5RTC6 New command.
Version info Available as of DLL 634, OUT 635, RBF 634.
References set_scanahead_params
Undelayed
Short List
Command
write_port_list