Siemens SINUMERIK 828D User Manual

Index
Turning
916 Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
CYCLE899 - open slot
Function, 490
Input simple, 490
Parameter - input simple, 498
CYCLE92 - cut-off
Function, 388
Parameter, 389
CYCLE930 - groove
Function, 358
Parameter, 360
CYCLE940 - Undercut
Function - DIN thread, 363
Function - Form E, 361
Function - Form F, 361
Function - Thread, 363
Parameter - DIN thread, 364
Parameter - Form E, 362
Parameter - Form F, 363
Parameter - Thread, 365
CYCLE951 - stock removal
Function, 355
Parameter, 358
CYCLE952 - Grooving
Function, 415
Input simple, 416
Parameter - input complete, 418
Parameter - input simple, 420
CYCLE952 - Grooving residual material
Function, 420
Parameters, 422
CYCLE952 - Plunge turning
Function, 423
Input simple, 424
Parameter - input complete, 426
Parameter - input simple, 428
CYCLE952 - Plunge turning residual material
Function, 429
Parameters, 430
CYCLE952 - Stock removal
Function, 404
Input simple, 406
Parameter - input complete, 409
Parameter - input simple, 412
CYCLE952 - Stock removal residual material
Function, 412
Parameters, 414
CYCLE98 - thread chain
Parameter - input simple, 387
CYCLE98 - thread chain
Function, 382
Input simple, 383
Parameter - input complete, 385
CYCLE99 - Thread turning
Parameter - Input complete - longitudinal
thread, 370
Parameter - Input simple- face thread, 382
Parameter - Input simple- longitudinal thread, 373
Parameter - Input simple- tapered thread, 377
CYCLE99 - Thread turning
Function - Face thread, 366
Function - Longitudinal thread,
366
Function - Tapered thread, 366
Input simple, 366
CYCLE99 - Thread turning
Parameter - Input complete - tapered thread, 375
CYCLE99 - Thread turning
Parameter - Input complete - face thread, 380
Cycles
Current levels, 219
Hiding cycle parameters, 231
Screen forms, 219
D
Data block (SB2), 125
Deep-hole drilling - CYCLE83
Function, 306
Input simple, 306
Parameter - input complete, 310
Parameter - input simple, 310
Deep-hole drilling - CYCLE830
Function, 312
Input simple, 312
Deep-hole drilling 2 - CYCLE830
Parameter - input complete, 319
Parameter - input simple, 319
Delete
Multitool, 725
Deleting
Directory, 756
Program, 756
Device
Activate/deactivate, (See Easy Extend)
Enabling, (See Easy Extend)
Dictionary
Importing, 59
Dimension
Absolute, 245
Incremental, 245
Directory
Copying, 754
Creating, 742
Deleting, 756
Highlight, 752

Siemens SINUMERIK 828D Specifications

General

Control Type	CNC
Operating System	Windows Embedded
Processor	Intel Atom
Display	10.4" color TFT display
Interfaces	Ethernet, USB
Programming	ShopMill, ShopTurn
Operation Panel Size	10.4"
Protection Class	IP65
PLC Memory	2 MB
Spindle Capacity	4 spindles
Hard Drive	CompactFlash