EasyManuals Logo

ST STM32L4 5 Series User Manual

ST STM32L4 5 Series
1830 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #615 background imageLoading...
Page #615 background image
DocID024597 Rev 5 615/1830
RM0351 Digital-to-analog converter (DAC)
647
19 Digital-to-analog converter (DAC)
19.1 Introduction
The DAC module is a 12-bit, voltage output digital-to-analog converter. The DAC can be
configured in 8- or 12-bit mode and may be used in conjunction with the DMA controller. In
12-bit mode, the data could be left- or right-aligned. The DAC has two output channels, each
with its own converter. In dual DAC channel mode, conversions could be done
independently or simultaneously when both channels are grouped together for synchronous
update operations. An input reference pin, V
REF+
(shared with others analog peripherals) is
available for better resolution. An internal reference can also be set on the same input.
Refer to voltage reference buffer (VREFBUF) section.
The DAC_OUTx pin can be used as general purpose Input/Output (GPIO) when the DAC
output is disconnected from output pad and connected to on chip peripheral. The DAC
output buffer can be optionally enabled to allow a high drive output current. An individual
calibration can be applied on each DAC output channel. The DAC output channels support
a low power mode; the sample and hold mode.
19.2 DAC main features
The DAC main features are the following (see Figure 137: DAC channel block diagram)
Two DAC converters: one output channel each
Left or right data alignment in 12-bit mode
Synchronized update capability
Noise-wave and Triangular-wave generation
Dual DAC channel for independent or simultaneous conversions
DMA capability for each channel including DMA underrun error detection
External triggers for conversion
DAC output channel buffered/unbuffered modes
buffer offset calibration
Each DAC output can be disconnected from the DAC_OUTx output pin
DAC output connection to on chip peripherals
Sample and hold mode for low power operation in Stop mode
Input voltage reference,
V
REF+
Figure 137 shows the block diagram of a DAC channel and Table 121 gives the pin
description.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ST STM32L4 5 Series and is the answer not in the manual?

ST STM32L4 5 Series Specifications

General IconGeneral
BrandST
ModelSTM32L4 5 Series
CategoryMicrocontrollers
LanguageEnglish

Related product manuals