INTRODUCTION, Root Menu
Sysmex SF-3000 Operator's Manual -- Revised September 1995 1-15
[Mainte.]
Use this menu to perform the customer maintenance programs, such as waste chamber
cleaning, clog removal, etc. and to perform the system test programs.
[Settings]
Use this menu to set the system parameters and conditions, such as date, time, units,
analysis stop condition, etc. Also this program contains data analysis settings to
establish certain standards for the SF-3000 system. System's operational parameters can
be set up to meet individual laboratory preferences to customize the operation of the
SF-3000. Refer to Chapter 11: System Setup for the setup procedure.
[Calib.]
Use this menu to calibrate the SF-3000 for specified parameter(s) automatically or
manually. Refer to Chapter 7: Calibration for the procedure.
[Shutdown]
Use this menu to clean the detector chambers and all hydraulic lines in the SF-3000
system with detergent.
[Auto Rinse]
Use this menu to rinse the hydraulic lines with the diluents, and check the background
values after rinsing. If the background values exceed the preset limit values, a
"Background Error" occurs.
To Next Page
Loading...
