INTRODUCTION
1-14 Sysmex SF-3000 Operator's Manual -- Revised September 1995
9.2 Root Menus
When the instrument power is ON, the Main Screen with the Root Menus is displayed as
the initial screen. By pressing the [Return] key on any screen, the visible display returns
to the previous screen, finally to the Main Screen.
The SF-3000 provides twelve Root Menus. The Main Screen displays seven Root
Menus on the menu line at a time. When you want to change a menu, press the [More]
key to alternate root menu.
The Root Menus is listed below. Each Root Menu consists a second menu(s) or menu
choices to proceed for the corresponding program.
[Status]
Use this menu to check the analyzer condition, analysis process, sensor status, etc. at
any time. (This menu does not display analysis errors.)
[Work List]
Use this menu to display, register, and process the analysis information, including
Sample No., Rack No., Tube Position, Order Information, etc. Refer to Chapter 3:
Work List for more information.
[Stored Data]
This menu provides options to display analysis results up to 1,000 samples stored in the
memory. The Stored Data List includes Date and Time analyzed, Sequential No.,
Sample No., Rack No., Tube Position, output status to the peripherals, flag information
and analysis results. Refer to Chapter 4: Result Interpretation/Reports for more
information.
[QC]
The SF-3000 quality control program provides X or L-J, and X M control
applications. The QC Root Menu performs QC analysis, displays and/or outputs the QC
Chart, establishes the QC settings, etc. Refer to Chapter 6: Quality Control for more
information.
[GP Print]
Use this menu to get options to output the data currently displayed on the screen to the
Graphic Printer.
[DP Print]
Use this menu to get options to output the data currently displayed on the screen to the
Data Printer.
[Replace Reagent]
Use this menu after replacing a reagent container to prime the reagent into internal
reservoir chamber.
To Next Page
Loading...
