QUALITY CONTROL, Sampler QC Analysis
6-46 Sysmex SF-3000 Operator's Manual -- Revised September 1995
• <QC Analysis Error>
This message appears if an analysis error occurs during QC analysis. Reanalyze
the sample.
The results are not plotted, or not stored as control data.
• Control Expired
This message appears if the analyzed control lot is expired. Analyze a new lot.
The results are not plotted, or not stored as control data.
NOTE: The expiration date of SF CHECK is monitored if the expiration
date information is entered in the control file. "Control Expired"
will be reported when SF CHECK is analyzed and the lot has
already expired.
This error also occurs when the expiration date is not entered in
the control file.
NOTE: Refer to
Chapter 8: Troubleshooting
for QC error information.
To Next Page
Loading...
Need help?
General
